(v5/v6 note: Since the WRT54G/GS v5-v6 uses a modified WAP54Gv3 once made 'linux ready', it will not accept these standard WRT54G/GS firmwares. These versions were just made specifically for TFTPing to those routers. You CAN use this to flash via web interface but do so only AFTER you have done so using the mini version. Generic version for flashing via web interface on all supported devices (including Linksys WRT54G/GL/GS) and for flashing Siemens SE505 with boot tftp on 192.168.2.1 Below are example file versions where represents mini, std, voip, etc.: After initial flash use any version, assuming it fits the flash size.
SNMP DD WRT V24 SP2 UPGRADE
To upgrade from the stock Linksys firmware, first flash the mini version from the web interface.
Atheros builds are still pre-baked and specific to its unit, so features in one unit's version may slightly differ from another unit's version.īroadcom based devices have several different versions available to choose from. So basically, Atheros 4MB flash units have features somewhat similar to a Broadcom K2.6 mini version while 8MB Atheros flash units have features more similar to a Broadcom K2.6 BIG version, but the features will vary. The feature set in Atheros builds are generally limited by the amount of flash memory that a unit has.
UBNT)Ītheros based devices typically only have one version of the firmware available per model. IBM's token-ring protocol may had made more logical sense, but it was more expensive to implement and ultimately did not provide substantial performance improvements over Ethernet.Atheros Based Devices (incl. While the method sounds incredibly inefficient, it's a tribute to Bob Metcalfe's insight that it works so well. In essence all the machines communicate locally by shouting out the destination IP address of the packets they generate and waiting for the target to grab its packets as they flow by over the wire. Only when traffic must leave the local subnet are routers involved. Remember that TCP/IP and Ethernet rely on broadcasts to communicate within the local subnet.
SNMP DD WRT V24 SP2 INSTALL
You can install ntop from the repositories.Įven then I'm not sure you'll see traffic that remains entirely within the local network. Then you can run something like ntop () on the Linux box and see all the network traffic. Make a Linux box be the internal network's default gateway and configure it to forward outbound traffic upstream to your router. Note the command in red needed to run vnstat as user instead of root. conkyrc content I use for the network display isĭOWN: $ I accept that if there are other machines using the network it will not be a accurate overall figure, but for my one main machine it is fine for me. Just to see what is going through my own computer I use vnstat and take the output from that into conky. The graphs on tomato are really easy to use.Īnother alternative is to force all other devices to use a transparent proxy and monitor that device. Any router running dd-wrt, tomato or pfSense can do it. For those, it really needs to happen on the router. don't think smart TVs, specialty media players, or Android/Apple are supported. This will only provide the view of monitored systems. On Ubuntu, the package dependencies should be is a little dated, but give the general idea for installation. One of the easiest ways that I know to bridge the end-user and server monitoring is with SysUsage. System monitoring is something that most end-users do not perform very well, IMHO. Otherwise, only a partial view can be provided.ĭesktop widgets are not the best way to monitor bandwidth use. That usually means it has to sit on the device where the bandwidth is used - or do it on the network equipment. To monitor network traffic the monitoring needs to see the traffic.
0 kommentar(er)
